A stylish Case for your Raspberry Pi™ A+ & 3 A.
It is simple to open! Simply loosen the 4 screws on top (no danger of breaking). The Micro-SD-Card is covered by the case, but still easy to push out, during to an additional cut out in the case. The "Style" case is made of 3mm Plexiglas (top/ bottom) and 2mm Plexiglas (in crystal clear) on the outside.
• 2x 3mm Plexiglas (top/ bottom)
• 4x 2mm Plexiglas (side)
• 8x M2,5x10 screws
• 4x M2,5x12 spacer
• 4x M2,5 nuts
• 4x M2,5 washer
Raspberry Pi™ Module not included!
Raspberry Pi is a Trademark of the Raspberry Pi Foundation
|Metal: Spacers, washers, nuts & screws|
|3mm top & bottom|
|Raspberry Pi A+|