An eyecatcher in every way! Very easy to set up and it is impossible to break anything, during the assambeling.
The Micro-SD-Card is covered by the case, but still easy to push out, due to an additional cut out in the case.
• 1x Plate for RCA, 1x Plate for AMP and 1x Plate for Digi 1,6mm wood optics
• 1x GPIO Plate 1,6mm wood optics
• 1x USB Plate & 1x SD-Part 1,6mm white
• Bottom plate 3mm Plexiglas white
• 1x Top plate 1,6mm wood optics
• A lot of screws, nuts & spacers
• 4 antiskid pads
Raspberry Pi™ 3 Module & JustBoom Hat not included!